close
close

How To Replace Toilet Shut Off Valve On Pvc Pipe

How To Replace Toilet Shut Off Valve On Pvc Pipe. Cover one end of the pvc piping with pipe dope and slide the shutoff valve onto it. With the compression nut loosened, simply pull the old valve off of the pipe.

Replace Toilet Shut Off Valve from www.tcworks.org

It looks way cooler too. Plan where you’ll place the shut off valve. When you cut the supply line, use the shark bite ball valve in the open position.

Plan Where You’ll Place The Shut Off Valve.

As the water begins filling the. To do this, simply grab the coupling and turn it until it becomes loose. Cover one end of the pvc piping with pipe dope and slide the shutoff valve onto it.

The Shut Off Valve Is Metal.

Put pvc glue on the pipe and push the “open valve” on the pipe. If installing a new sweat valve, remove enough solder for the new part to slide onto the pipe. Glue them on one at a time by spreading pvc cement on the end of the pipe and on the inside of one end of the fitting with the applicator that comes in the can of glue.

Check The New Valves For Leaks.

Allow the adhesive to dry according to the manufacturer's instructions printed on the can. Once the tank has been drained, you will need to disconnect the valve from the water supply line. Yeah i'm definitely throwing a stainless supply line on it either way.

Unscrew And Disconnect Your Supply Line (S).

Cut the pipe just below the existing valve. In most cases, this line will be attached to the toilet via a special coupling, which can be loosened by hand. Apply the teflon in the threaded inside of the adapter and smoothen the teflon using your fingers.

It Looks Way Cooler Too.

First, open the valve, then cut the supply line. This is the last toilet in my house i'm overhauling and i'm so pumped. With the compression nut loosened, simply pull the old valve off of the pipe.

Leave a Reply

Your email address will not be published.